If you have a slow-moving clog in your kitchen sink, you may not be able to use drain cleaner on your own. In this case, you may need the help of a plumber. However, you can try to use a wire coat hanger as a drain snake. All you have to do is feed the wire into the drain and crank it until it breaks through the clog. If this doesn't work, you can always unwind it with a pair of needle-nose pliers.

Unclog a kitchen sink

Another way to unclog a kitchen sink is to pour boiling water into the drain. It works by releasing the trapped water, causing it to fizz and dissolve the clog. You must pour the boiling water slowly into the drain to avoid splashing. After 15 minutes, you can run a hot water stream through the sink and flush out the drain. If this still doesn't work, you can try other drain cleaners, such as baking soda, which will work even better.

Mix baking soda and vinegar

In addition to using drain cleaners, you can try to clean your kitchen sink by pouring a mixture of baking soda and vinegar into the drain. The mixture will cause a bubbling reaction and break up the bigger pieces of muck. Alternatively, you can use a basket strainer or wet rag to cover the other opening of the sink. When you pour boiling water, make sure to use gloves. Once you've done this, you can use the hook several times and dispose of the debris.

A wire coat hanger can help unclog a double-bowl sink. Place the plunger base flat against the drain surface. This will create a vacuum, which will unclog the sink. But be sure not to pour Drano down the drain before you start plunging. Otherwise, it might splash back onto you. To prevent this, try to use a different drain cleaner first, before pouring Drano.

Plungers are great tools for removing clogs in a sink. The flat rim on a plunger makes a seal over the hole and helps to apply pressure on the clog. To use a plunger, fill the sink with three to four inches of water and place the plunger on the clogged side. Plunging for 30 seconds should break up the clog and help the water drain.

Use boiling water

Some homeowners prefer a vinegar and baking soda mix for their drain problems. Others prefer Drano or Liquid Plumr. When using these substances, make sure to wait at least 15 minutes before flushing the drain. If this method doesn't work, you can also use boiling water. Just make sure that you don't mix any chemicals with them before letting the baking soda and vinegar mixture sit in the sink.

Prevent water spots

A simple way to clean the sink is to apply baking soda to the sides of the basin. Then, pour some dish soap on it to clean the rest of the sink. Then, use a sponge or brush to scrub the rest of the basin and the drain. Repeat the procedure as necessary until the sink is scum-free. To prevent water spots, dry the sink thoroughly with a microfiber cloth.